Qmtech Zync 7z020 board
I was trying to run it with AD6645-105 and overclock it to 122.88mHz, but ADC chip was dead 🙁 Ordered new one
Playing with filters for Wolf 3.5″
Replaced inductors with non-smd: 160m: New: 80m: Old: New: 40m: Old: New: 30m: Old: New: 20m: Old: New: 18Mhz: New: 15m: Old:
Different inductors in BPF
Replaced inductors in BPF — 2 handmade and other non-smd inductors from aliexpress. I forgot to make a photo of the result
Wolf 3.5″ battery
Wolf 3.5″ is finished too.
There is some tuning needed, but almost nothing to solder anymore, just 2m filters mods required. And all works.
Wolf 3.5″ first QSO
80watt VHF module is working.
There are some place for modifications and tuning, but… assembly for big wolf is finally finished… I hope I’ll never repeat it
Display for microscope
Was struggling to understand what was overheating :)
SWR was increasing and power was lowering. Was trying to figure out whats wrong… Finally…
Wolf 7″ RX circuit measurements.
I’m using not best quality 0805 inductors (it’s just too hard to buy good here in Batumi) from aliexpress so BPF loss